Home > Tv Link > Sky Tv Link Magic Eye Not Working

Sky Tv Link Magic Eye Not Working

Contents

If the above does not help our highly recommended Installer guide is available from http://www.tvlink.co.uk/installers-guide.htm I have a Sky HD STB, how do I turn on RF out 2? Amstrad DRX595 The DRX595 SkyHD Digibox has no Hard Drive, no Scart output and no RF connections. We sell RG6 coax which is perfectly OK for indoor use (aluminium foil shield and quite flexible). There is a summary of how to do a correct reset on Sky's Help Centre Accessories pageLast resort: Try connecting the TVLink direct to the Sky RF2 socket on the back this contact form

you can flick the channels from the box and the same picture comes up on both tv's but stilll not light on the link. In addition, the down-lead from the TV aerial should be double-screened for at least the bottom two metres. If it works at the main Sky box it could be there is something along the cable run to the second location that is stopping the DC signal from getting back Disconnect the tvLINK from the back of the second TV and connect it directly onto the back of the Sky box, no cable just the tvLINK female connector into RFOut2. http://helpforum.sky.com/t5/Remotes-accessories/Issues-with-TV-Link-magic-eye-not-working/td-p/1996376

Sky Tv Link No Red Light

As above, check your connections. can you please explain, can you send link to any pictures perhaps? This won't matter with most TV sets but with some it does. niall campbell View Public Profile Find More Posts by niall campbell 12-06-2007, 20:11 #3 coopermanyorks Forum Member Join Date: Jan 2003 Location: In Gods Own County Posts: 20,677 Hi

Any ideas or helpful advice please!!!!!????? Find More Posts by coopermanyorks 14-06-2007, 08:17 #19 pkb Forum Member Join Date: May 2005 Location: West London UK Posts: 345 Quote: Originally Posted by 1saintly hi pkb, if You bought something else from SatCure worth more than £10 ? Tv Link Eye Not Working Dstv It does present a problem because extra depth is needed behind the wall plate to allow the cable to curve gently.

This was connected to the TV aerial as we are in a poor TV signal area and right smack between 2 transmitters (Dover and Crystal Palace). Harmonics can also cause a problem, try to avoid multiples of 11 metres (CT100 and Equivalent). To check, key Services > Settings > Picture. Here we cover fault finding for two different scenarios, one when the LED is lit, and one when the LED is not lit.

Does it run direct to the telly, or is there a distribution/booster box along the way? Sky Magic Eye Stopped Working The "magic eye" infra red sensor may not work if it is placed on, or very close to, a TV set which is emitting interference. Published on Mar 2, 2012http://www.tvtrade.ie/sky-magic-eye-e... wall plates splitters, boosters etc., or the cabling is NOT double screened and there is noise leaking through, which will also stop the signals.

Sky Magic Eye Remote Not Working

The cost is low and it will lead you to the cause of your problem if you follow the simple troubleshooting checks. From help in programming your remote to the features of our On Demand connectors. Sky Tv Link No Red Light JCVAerials 27,512 views 4:07 Instructions & Demo on How To Program Set Up The Sky Remote Control To Your Television Samsung Etc - Duration: 2:20. No Red Light On Magic Eye We recommend you simply change it for a different model and save the hassle.

To avoid having to solder, you can use a splitter: click HERE. weblink Alternatively, you could fit a "Bypass" unit but this might have a detrimental affect on the signal because it adds two in-line connectors. much appreciated. Thanks ProDave, will have to re do the braid as I did not do this properly I guess. Tv Link Magic Eye No Red Light

What have I done wrong? If you have a problem with our product you must please specifically state that you've downloaded and read our Guide and carried out the listed tests, when contacting us. Monoprice 7,748,361 views 3:24 My Freeview TV Set Up - Duration: 3:30. navigate here Some wall plates, splitters and amplifiers will stop the DC signals from getting back to the Sky box, if you have any of these fitted somewhere in the cable run you

Which plugs Wire my house X-Ray Remote 304114 wall plate FAQs BLOG Contact Us

Sky magic eye problem? Tv Link Not Working With Sky Hd Box The Sky Digibox is able to supply sufficient power through the RF2 Output port to power up to a 4 way distribution amplifier and 4 tvLINKs and so will not require the red light in the sky eye I have for my Tv is illuminated, but when i connect to to the Tv connection it goes out, and I have no channels.

This brings up another point: terrestrial digital TV transmissions are terribly susceptible to problems with car ignition interference and of switching transients within the building.

I have one that works in the bedroom just as stated above, but would like one for the main TV so that I can move the box out of sight. Tip: When screwing the cap to the main body causing the clamp to tighten, make sure you have all the copper braiding pulled back as this must NOT touch the centre Go to the tv link, and 2nd tv, you get the same picture as on original tv, but there is no light on on the link! Sky Tv Link Remote Not Working If you install you Magic Eye and the red or green light is ON on the magic eye then you do not have to read the next part of this web

Press the SIDE ARROW button once [turning power on]. SMITTYMOVIES 1,089,544 views 2:14 How to wire an F connector - Duration: 8:03. The main culprits are lights (especially "energy saving", fluorescent and the high brightness mercury and sodium types), TV sets, computer monitors and some sources of radio interference, too. his comment is here Press the NUMBER 4 button [System Set-up].

Autoplay When autoplay is enabled, a suggested video will automatically play next. If the light comes on when plugged straight in the box, then there is a problem with the cable run, if it does not, then the problem lies with the digibox pkb View Public Profile Find More Posts by pkb 13-06-2007, 19:09 #16 pkb Forum Member Join Date: May 2005 Location: West London UK Posts: 345 Quote: Originally Posted by Picture of a sky magic eye So you now have the one end of the aerial cable fitted to the Sky Box downstairsand the other end fitted into the Magic Eye

Transcript The interactive transcript could not be loaded. You do it at your own risk. THanks for all your help. Capacitor Kits CAT5 plug fitting Channels Chimney Brackets Chimney Strap Coaxial Cable Cooling fan Combiners Compass use Cupboard Control DAT45 aerial DC inserter Decouple cable Denso Tape Digibox Problem Digibox Internals

Disconnect the tvLINK from the second location and take it to your Sky set-top box. I know the following doesn't immediately answer your questions, but it may help understand what teh set up is in my house.The previous set up was a Televes Amplifier ref. 8126 Problems with my TV Link. This is most easily arranged by stripping the guts out of a wall plate socket and gluing in a suitable female coaxial plug. (This can be of the usual TV "IEC"

XXgameofs 6,692 views 7:52 Problems, Troubleshooting and Solutions to IO Link Issues - Duration: 3:58. have you switched its power on in secret menu? If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices.